SE40516

Cabinet/Swipe Sensor Switch

This attractive IR sensor has 2 functions; use under cabinets as a swipe on/off sensor for the connected lights. Alternatively, mount inside a kitchen cabinet or wardrobe to act as a door sensor for internal lights.

From: £17.64
Where to buy
Ordering options
 CodeDriverMax. Wattage
SE40516
15/30W

CodeDescriptionStockColour Coding
SE40525 15W LED Driver with 6 Port JB4 Distributor InStock
SE40526 30W LED Driver with 12 Port JB4 Distributor InStock
SE40553 6W Driver with 4 Port JB4 Distribution Block InStock
SE40555 15W LED Driver with 6 Port JB4 Distributor InStock
SE40556 30W LED Driver with 12 Port JB4 Distributor InStock
SE40557 50W LED Driver with 12 Port JB4 Distributor InStock
SE40625 6W LED Driver with 4 Port JB4 Distributor InStock

Product Features
  • FinishAluminium

    Hint

  • Cable Length1.5 metres

    Hint

Key points:

> Can be used with 12V & 24V LED products (without an integrated sensor)

> Works as an on/off switch for these fittings

> Two functions of the sensor:
• Mount inside a cabinet – open door to activate light
• Mount under cabinet – lights are activated when a hand passes before the sensor

> 5-10cm detection range, so unwanted detection is not a problem

> Can be surface mounted or recessed into a pelmet

> Plug and play, and no additional wiring is required by the electrician

Product FAQs

Can I wire 2 or more sensors into one driver?

No, this sensor must be wired individually back to it's own driver only. If more than one sensor is connected to the same driver the function of each sensor is interfered with by the other sensor(s) connected, causing your lighting circuit not to run as you'd expect.

x

Selecting the right driver

Divide the wattage of the driver by the wattage of a single light to determine how many lights can be run by the driver.

For example, 15W driver with 3W lights
15 ÷ 3 = 5 lights

Drivers are available in more than one wattage, work out the best option based on the number of lights you have.

Drivers have a limited number of ports. A driver with 6 ports is therefore limited to a maximum of 6 lights.

Ensure you consider both the wattage and number of ports on the driver.

x

Connecting by Colour

To simplify the process of selecting the appropriate driver for your lighting, Sensio use a simple colour coding system.

All components are colour coded:

driver
x

Log in to your Trade Account

(Have you forgotten your password?)

Forgotten your password?

Don't worry, we can reset this for you. Just enter the purchasing contact email address for your Sensio account below and we'll send your new password. You can then change that password in your account dashboard after you've logged in.

Back to login

Would you like a Trade Account? Apply Now

By continuing to use the site, you agree to the use of cookies. More information