How many flexible strips can be run from one driver?
A maximum length of 12m of this flexible strip can be run from one 30W driver (SE40526).
What do I need to run the flexible strip?
For each run of the flexible strip you will need a 2.5m driver connection lead and a driver with an adequate wattage to run the specified amount of flexible strip lighting.
How does the mini cut connector work?
A flexible strip can be cut ONCE (the points at which it is safe to cut are indicated on the strip by scissor marks). The cut end of the strip can then be reconnected to another strip or a new run can be stated. To do this you require the cut connector (see accessories below).
What's included in the packs?
Flexible strip(s) - the quantity and length of each strip is stated in the table.
A 2.5m driver connection cable.
A 15W Driver.
Can I run flexible strip lighting under a dishwasher?
The flexible strip itself cannot be run along/under the dishwasher, we supply extension cables for the flexible strips which would need to be interlinked and run around the back of the dishwasher to not break the run of strips.
Can I bend the flexible strip on a corner?
No, the flexible strip cannot be bent on a corner, to get around corners you should use the 50mm corner connection cable.
If I cut the flexible strip will the wattage remain the same?
No, the wattage of the strip would be reduced by how much is cut off (how many LED's). For example if a 2m strip has a wattage of 15W and 1m is cut off the wattage of the 2m strip will reduce to 7.5W.
One end of the flexible strip appears to be blank.
The male end of every flexible strip is supplied with an end cap covering the pins to protect them. For interlinking and connecting to the driver connection cable this end cap must be removed.